18
5.1.5 Verify HDD
Now press ESC to return to Function 12, and then select part 5 Verify HDD as the following figure
shows. Verify HDD is to verify if the hard disk or any of its partitions can work well.
12-05. Adv Setup
Verify HDD
Press ENT to enter the next figure. Use ▲ ▼ to confirm Disk or Parti.
Press ENT to verify. After verification LCD will show the results as follows.
Verify HDD
OK
5.1.6 Burn-in
Now press ESC and ▼ to enter the following figure. Burn-in is to simulate the copying progress
many times. The time can be from 1 to 1000. After each cycle of simulation, the medias on the
DVD writers will eject automatically and recede for the next bout of simulation.
Verify Disk or
Paration? Disk
12-06. Adv Setup
Burn-in
Press ENT to enter the next figure. Test is simply a simulation.
Burn-in
Test
Press ENT and use ▲ ▼ to select the time of simulation such as 1, 2, 3...1000 or Run
Continuous. The figure below shows Run Continuous.
Sel burn-in num:
Run Continuous
Press ESC, ENT, ▼ to select Erase & Copy as the following figure shows. Erase & Copy is to
erase and write repeatedly. It is only for media rewriteable discs.
Burn-in
Erase & Copy
Press ENT and use ▲ ▼ to select the time of simulation such as 1, 2, 3...1000 or Run
Continuous. The figure below shows Run Continuous.
Sel burn-in num:
Run Continuous
ARS-2057P/2050P Manual
Comments to this Manuals