Acard ACP-2200 User Manual

ACP-2200USB/eSATA to SATA & IDEDisk Mate-easy plug and playUser's ManualVersion: 1.0Copyright©2008 ACARD Technology Corp.Release: March 2008

2.4 Device-end connections2.4.2 2.5" IDE HDDThe ACP-2200 can be connected directly to the 2.5" IDE HDD2.5" IDE PortNote: The 2.5"

2.4.3 2.5" SATA HDDUse the included SATA cable to connect to the ACP-2200's SATA port. It is compatible with both SATA1/SATA2 ports. ACP-220

2.4.5 Connection RulesNote: ●Device priority is SATA1 > SATA2 > 2.5" IDE > 3.5" IDE●When host is set to eSATA mode, do not use the

Chapter 3 Configuration3.1 One Touch Backup (OTB)Before using the ACP-2200's OTB button, you must install the eSBR utility from the included CD-R

To backup data for the first time, follow the prompt and select “Back up Files and settings”. Use the mouse to click “Next”. 12Choose the data you wis

Choose the files on the computer to backup, then click on "Next":Choose where you want the data to be stored on the ACP-2200 and assign the

If you click on “Browse” a "Save as…” window will appear. Select the drive letter for the ACP-2200 and click on “Open” asAt the ACP-2200 hard dis

Finally, click on “Finish" to end the backup & recovery wizard and begin backing up your files:When the backup is under way, the backup progr

When done, click on “Close” to finish the backup process or click on “Report” to check the backup information as shown below:If you cannot properly us

In the pop-up Control Panel windows, click the “User Account” icon, as shown below:This brings you to the user account screen: 17ACP-2200 User's

In this window, click “Turn User Account Control on or off” and the “Turn User Account Control on or off” window as shown below appears. Then, clear t

3.2 Attention●This product's DC power supply can't be connected to the computer●A newly installed HDD must be formatted before it can be use

Appendix 1Installation of the Windows backup and recovery componentWindows system recovery and backup assembly are not included in the XP Home Edition

Install “NTBACKUP.MSI” directly, as shown below:After installation is complete, select Finish, as shown below:When the installation is completed you c

Technical Support Request FormMail to: [email protected]: http://www.acard.com*Model ACP-2200System InfoMemoryGraphics CardExpansion CardDevice

Copyright and TrademarksThe information of the products in this manual is subject to change without prior notice and does not represe

IndexChapter 1 Introduction... 1.1 Overview...

WEEE StatementIn order to cope with the increasing waste electrical and electronic equipment, reduce the use of landfill and incinerator, and prev

WEEE бюлетеньЧтобЫ сρaвиться с увеличивающимся ненуҗным электрическим и электронным оборудованием, уменъшите использование закапывания мусора и испо

x2x1x1x11.1 OverviewACP-2200 Bridge pro is the first product to provide USB and eSATA combo interfaces in the market. Through USB or eSATA

2.5”IDE PortSATA Device Port2OTB Backup ButtonSATA Device Port13.5”IDE PorteSATAT PortUSB/eSATA Switch(Factory Default:USB)USB PortLED DeviceStatus In

2.3 Host-end Connections2.3.1 The ACP-2200 provides two types of host connection interfaces: USB or eSATA. You can switch between them as shown below: